Each excavation advance leaves a stretch of rock or ground unsupported. Whether excavation uses blasting or mechanical methods, this exposed ground needs to be secured quickly. The longer it remains unsupported, the more the ground relaxes and deforms, increasing the risk of exceeding design limits or allowing blocks to fall.
Shotcrete is often the first form of support installed, and how it is applied affects safety, advance rates and costs. Underground, however, the tunnel cross-section varies, access routes are long, and spraying has to be coordinated with mucking out (removing excavated material) and the installation of rock bolts and steel ribs. Concrete is supplied from outside the tunnel, with delivery times that are not always predictable.
Shotcrete, also known as sprayed concrete or spritz beton, is a cementitious material projected at high velocity through a nozzle onto the surface to be lined. Application and compaction take place together: the impact compacts the material, without formwork or vibration. To adhere even to the crown, the upper part of the tunnel, the layer must set very quickly. An accelerator is therefore added to the mix.
Tunnel support has two distinct stages:
Initial support: shotcrete, steel ribs and rock bolts installed during excavation to stabilise the ground;
Permanent lining: usually cast-in-place concrete, installed once deformation of the initial support is subsiding at an acceptable rate; precast segments are used with shielded TBMs.
In some projects, shotcrete works together with the final lining or forms the final lining itself (sprayed concrete lining, SCL). Its role is defined by the design.
The excavation method influences how shotcrete is used. In drill and blast tunnelling, it supports the excavation alongside rock bolts after each blast. In NATM (New Austrian Tunnelling Method), it is the central element of a support system adapted to measured deformation. In ADECO-RS (Analysis of Controlled Deformation in Rocks and Soils), developed in Italy, it complements reinforcement of the core ahead of the face. With hard-rock TBMs (Tunnel Boring Machines), shotcrete is sprayed manually from a platform close to the cutterhead or by robotic systems further back.